Installation Instructions

ManualsBrandsEcolink Intelligent Technology ManualsElectronicsWater Sensor

redundant, the controller can disable the Sensor Binary Report Commands completely. The following table shows the values to enable and disable

the two configuration parameters.

Configuration Set Values

Effect

Parameter Number: 1

Size: 1

Configuration Value: 0x00

(Default) Sensor does NOT send Basic Sets to Node

IDs in Association Group 2 when the sensor is

restored ( i.e. Door/Window Closed ).

Parameter Number: 1

Size: 1

Configuration Value: 0xFF

Sensor sends Basic Sets of 0x00 to nodes in

Association Group2 when sensor is restored.

Parameter Number: 2

Size: 1

Configuration Value: 0x00

(Default) Sensor sends Sensor Binary Reports when

sensor is faulted and restored for backwards

compatibility in addition to Notification Reports.

Parameter Number: 2

Size: 1

Configuration Value: 0xFF

Sensor will send only Notification Reports and NOT

Sensor Binary Reports when the sensor is faulted

and restored.

FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Re-orient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment to an outlet on a different circuit from the receiver

• Consult the dealer or an experienced radio/TV contractor for help.

Warning: Changes or modifications not expressly approved by Ecolink Intelligent Technology Inc. could void the user’s authority to operate the equipment.

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,

including interference that may cause undesired operation of the device.

C’et appareil est conforme la norme d'Industrie Canada exempts de licence RSS. Son fonctionnement est soumis aux deux conditions suivantes: (1) c’et appareil ne peut pas provoquer d'interférences, et (2) c’et appareil doit

accepter toute interférence, y compris les interférences qui peuvent causer un mauvais fonctionnement de la dispositif.

FCC ID: XQC-DWWZ25 IC: 9863B-DWWZ25