Installation Instructions

© 2020 Ecolink Intelligent Technology Inc. PN DWWZWAVE2.5-ECO R1
Network Inclusion/Exclusion: Key Points to Remember
• Controller inclusion/exclusion mode must be activated BEFORE starting sensor inclusion or exclusion mode.
• The sensor can only be included into one controller network at a time, and must be excluded from one network before inclusion in another.
• The plastic pull tab must be removed to enable sensor operation.
• The sensor automatically enters inclusion mode at power-up.
• Exclusion mode on the senor is initiated following the same exact procedure as inclusion.
LED Status
The Water Sensor is equipped with a single LED. The state of the LED will change based on the state of the device.
Device not included
State Change: Water Detected or Removed from Probes
Case Opened
= Light breathing (slow blink)
= Single LED blink
= LED will remain on while case open
Tes
ting
To test the RF transmission from the mounted position you can generate a tamper by removing the cover. This will send a signal to the Z-Wave controller.
To test water detection, place the probe in a cup of water and remove, this will toggle the status state from open to closed.
Repl
acing the Battery
When the battery is low a low battery notification will be sent to the life line nodes. To replace the battery:
1. Remove the top cover to reveal the battery. This will send a tamper signal to the lifeline nodes.
2. Replace with a Panasonic CR123A battery ensuring the + side of the battery faces as indicated on the device.
3. Re-attach the cover, you should hear a click when the cover engages properly.
Inst
allation
The package contains the following:
1- Water Sensor with Probe
1- Sensor Mounting Bracket
2- Screws for Sensor Mounting Bracket
1- Adhesive tape for Sensor Mounting Bracket
2- Screws for probe
1- Adh
esive tape for mounting Probe.
1- Wire Clip