Setup Guide

PN: CS-902-MA03
CS-902 ClearSky Chime+Siren
Specifications
Frequency: 345MHz & 2.4 GHz Operating Temperature: 32°-120°F
Power: 120VAC, 60Hz, 0.25A Max US Operating Humidity: 5-95% RH
Decibel Rating: 105 dB @ Max Volume Indoor Use Only
The ClearSky Chime+Siren will play designated Chime and Siren sound effects
when used with a ClearSky Bridge.
To test the Chime+Siren, power the device on and press the volume buttons on
the side to verify functionality.
FCC ID: XQC-CS902 IC: 9863B-CS902
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for Class B digital devices,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Re-orient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment to an outlet on a different circuit from the receiver
• Consult the dealer or an experienced radio/TV contractor for help.
Warning: Changes or modifications not expressly approved by Ecolink Intelligent Technology
Inc. could void the user’s authority to operate the equipment.