Installation Guide
Table Of Contents
- Product Overview
- The remote temperature sensor is wall mountable remote sensor for use with any ClearSky™ compatible system. This sensor is ideal for remotely monitoring room temperature and reporting back to control panel or thermostat. The CS-502 also supports ext...
- Features
- Specifications
- Package contents
- Installation Instructions
- Pairing
- To pair the sensor, set your ClearSky Compatible Controller into sensor learn mode. Refer to your specific ClearSky Compatible Controller instruction manual for details on these menus.
- On the temperature sensor, locate the learn button above the external probe connector. Initiate pairing by pressing the the learn button. Repeat as needed by the ClearSky Compatible Controller.
- Unpairing
- Testing
- FCC Compliance Statement
© 2020 Ecolink Intelligent Technology Inc. PN CS-502
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B
digital devices, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Re-orient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment to an outlet on a different circuit from the
receiver
• Consult the dealer or an experienced radio/TV contractor for help.
Warning: Changes or modifications not expressly approved by Ecolink Intelligent
Technology Inc. could void the user’s authority to operate the equipment.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
C’et appareil est conforme la norme d'Industrie Canada exempts de licence RSS. Son
fonctionnement est soumis aux deux conditions suivantes: (1) c’et appareil ne peut
pas provoquer d'interférences, et (2) c’et appareil doit accepter toute interférence,
y compris les interférences qui peuvent causer un mauvais fonctionnement de la
dispositif.
FCC ID: XQC-CS502
IC: 9863B-CS502
DISCLAIMER AND LIMITATION OF LIABILITY
OTHER THAN THE LIMITED WARRANTY ABOVE, ECOLINK MAKES NO OTHER
WARRANTY OR REPRESENTATION, AND HEREBY DISCLAIMS ANY AND ALL
IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, THE IMPLIED
WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE. YOU ACKNOWLEDGE THAT YOU ALONE
HAVE DETERMINED THAT THE PRODUCT WILL SUITABLY MEET THE
REQUIREMENTS OF THE INTENDED USE.
IN NO EVENT SHALL ECOLINK OR ANY OF ITS AFFILIATES BE LIABLE FOR ANY
INCIDENTAL, SPECIAL, INDIRECT, CONSEQUENTIAL, OR MULTIPLE
DAMAGES, INCLUDING BUT NOT LIMITED TO, LOST PROFITS, LOSS OR
DAMAGE TO SOFTWARE OR DATA, OR DAMAGE TO EQUIPMENT ARISING
OUT OF THE USE OF ANY PRODUCT, EVEN IF ECOLINK HAS BEEN ADVISED
OF THE POSSIBILITY OF SUCH DAMAGES. FURTHER, IN NO EVENT SHALL THE
LIABILITY OF ECOLINK OR ITS AFFILIATIES EXCEED THE INDIVIDUAL PRICE OF
THE PRODUCT ON WHICH LIABILITY IS ASSERTED.
By the act of use, setup or assembly of the product, you accept all resulting
liability. If you as the purchaser or user are not prepared to accept the liability
associated with the use of the product, you are advised to return the product
immediately in new and unused condition to the place of purchase. Some
states do not allow the exclusion or limitation of incidental or consequential
damage, so the above limitations may not apply to you.