Installation Guide

© 2020 Ecolink Intelligent Technology Inc. PN CS-502
Pairing
To pair the sensor, set your ClearSky Compatible Controller into
sensor learn mode. Refer to your specific ClearSky Compatible
Controller instruction manual for details on these menus.
On the temperature sensor, locate the learn button above the
external probe connector. Initiate pairing by pressing the the learn
button. Repeat as needed by the ClearSky Compatible Controller.
Unpairing
Any ClearSky™ Device can be removed from any ClearSky™
compatible controller. Follow the directions to put your ClearSky™
Controller into exclusion mode to remove the device.
Testing
To test the signal transmission from the desired location, press the
learn button. It will report the temperature value.
Battery State
The temperature sensor will alert the controller when the batteries
become low. While the batteries are low, the controller will report
the battery level as defined in its operation. The temperature sensor
will continue operating until the batteries are completely depleted.
Replacing the Battery
When the battery is low a signal will be sent to the control panel. To
replace the battery:
1. Carefully remove the front cover by prying on the bottom plastic
tab.
2. Replace battery with two AAA batteries.
3. Reinstall the front cover.
Plastic Tab