User's Manual

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject
to the following two conditions: (1) This device may not cause interference; and (2) This
device must accept any interference, including interference that may cause undesired
operation of the device.
CAN ICES-3 (B)/NMB-3(B) – This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
The FCC ID of the device in this package can be found on the back or bottom of the
device.
CAUTION
To reduce the risk of electrical shock, DO NOT open the unit. There are no user
serviceable parts inside the unit. Refer to customer support for any repairs.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same of
equivalent type recommended by the manufacturer. Dispose of the used batteries
according to the manufacturer’s instructions.
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
1523 26th St.
Santa Monica, CA 90404
Ring_Motion_Detector_legal.indd 1 9/11/17 6:55 PM