User's Manual

ManualsBrandsEcolink Intelligent Technology ManualsElectronicsRing Contact Sensor

Home security

beyond the front door

Ring Video Doorbells began a Ring of

Security around your entire property.

Ring Protect is the security system that

takes the Ring of Security a step further

giving you another level of protection for

your property.

Now, you can arm and disarm your

system, prevent crime and protect your

home - all from your phone, tablet or PC.

Contents

1. Diagram

2. In-app Setup

3. Connecting the Device

4. Physical Installation

5. Troubleshooting

Diagram

Set up your Ring Contact Sensor

near your Base Station

In the Ring app, choose Set Up a Device.

Choose Sensors, then Ring Contact

Sensor, then tap Add Device.

Pull the tab on the sensor

This connects the battery and turns on

the device. Your base station will find it.

12345

Scan the QR Code or enter the S2

The QR Code and PIN can be found on

the back of your device, on the box, or on

the card in this box.

12345

Contact Sensor

Say hello to

your Ring

Contact Sensor.

LED

RingSensor Magnet

Set up your

Ring Contact

Sensor in the

Ring app.

Connect your

Ring Contact

Sensor to your

base station.

Ring_Contact_Sensor_manual.indd 1-2,4-6,8,10 9/6/17 9:23 AM

Summary of content (4 pages)

PAGE 1
Ring Protect is the security system that takes the Ring of Security a step further giving you another level of protection for your property. Now, you can arm and disarm your system, prevent crime and protect your home - all from your phone, tablet or PC. 2. In-app Setup 3. Connecting the Device Sensor LED Ring Magnet 2. S et up your Ring Contact Sensor in the Ring app. Set up your Ring Contact Sensor near your Base Station In the Ring app, choose Set Up a Device.
PAGE 2
Your sensor will try to connect to your base station. The sensor’s LED ring will show the progress. Here are some common LED patterns: Waiting to connect Blue Blinking (30 sec) Connected Blue Solid (5 sec) Couldn’t add to base station Blue Blink (5x, quick) Door or window open Blue Blink (1x) Sensor tampered Blue Blinks (3x) Ring_Contact_Sensor_manual.indd 20 Open and close the sensor to test it Make sure the app shows that the sensor is open when you pull it apart. 4.
PAGE 3
1523 26th St. Santa Monica, CA 90404 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with Industry Canada’s licence-exempt RSSs.
PAGE 4
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. Protect the device from direct sunlight. Install the device at dry locations, and protect it against rain and humidity.