Owner's Manual

22
Adjustment of timer settings on the printed circuit board
On the printed circuit board the following
times/delays can be adjusted:
Pump starts after fl ow signal has turned ON.
Pump stops after fl ow signal has turned OFF.
01167
Dipswitches
Starting up of compressor (if mounted).
1 sek.
2 sek.
4 sek.
8 sek.
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
ON
OFF
ON
OFF
ON
OFF
ON
OFF
Pump start to be adjusted on the dipswitches 3 and 4:
Pump stop to be adjusted on the dipswitches 1 and 2:
Compressor to be adjusted on the dipswitches 3, 4 and 5:
NOTE! When dipswitch 5 is OFF, the compressor setting is active meaning that the pump will start without any
delay when the fl ow signal has turned ON.
The compressor will stop without any delay when the fl ow signal is OFF.
ALTO does not recommend you to change the dipswitch settings unless absolutely necessary.
1 sek.
2 sek.
4 sek.
8 sek.
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
ON
OFF
ON
OFF
ON
OFF
ON
OFF
10 sek.
20 sek.
30 sek.
40 sek.
27038
27039
27040
7. Adjustment of printed circuit board (S4000/S4100)
1 sec. 4 sec.
1 sec.
4 sec.
8 sec.
10 sec. 30 sec.