User Manual

Patient Safeguard System® Patient Bed Installation
UltraClenz, LLC
Page 17
 Bed Number: example – “001” (optional metadata). The installer can choose to place a numbered label at the
bed’s footboard frame to easily identify beds because the Bed Beacon label may not be in a convenient location to
easily view.
 Bed Make: example – “Hill Rom” (optional metadata). The bed manufacturer information can assist staff in
identifying a bed.
 Bed Model: example – “Versacare” (optional metadata). The bed model information can assist staff in identifying a
bed.
 Bed Serial Number: example – “123456” (optional metadata). The bed serial number information can assist staff in
identifying a bed.
Figure 20. Bed Beacon Metadata
6.2 Replacing an Existing Bed Beacon – Swapping Metadata
Remove the Bed Beacon and read the address from the product label. Enter the Bed Beacon’s address in the active
Bed Beacon device list (see Figure 19 above). Click the replace icon in the device list “Action” column (see Figure 19).
The replacement tab will open. Enter the new Bed Beacon’s address into the blue box. Check the “I have verified the
device ID” then click “Replace” to transfer the old Bed Beacon’s red box to the new Bed Beacon blue box (see Figure
22). The old Bed Beacon will be marked for repair and deleted from the active device list. Click “Replace Another
Device?” to replace another Bed Beacon.
Figure 21. Replace Icon