User Manual

ProClenz DSP2000 Performance UltraClenz, LLC
Page 4
Figure 3 Badge Control
2.4 Badge Settings (refer to Figure 4)
Badge settings are used to change the five most often adjusted settings that control the behavior of the Badge.
Figure 4 Badge Settings
Audio Volume consists of three radio buttons used to set the volume of the audio reminders for all states. “Off”
turns off all of the Badge’s audio reminders. “Low” sets the Badge’s audio reminders to low audio volume. “High”
sets the audio reminders to their highest level.
LED Brightness also consists of three radio buttons but is used to set the brightness of the visual reminders. Off”
turns off all of the Badge’s visual reminders. “Low” sets the Badge’s visual reminders to a dim visual level. “High”
sets the visual reminders to their highest level.
The Grace Periods section contains three fields for entering the time that a grace period lasts. The user can
enter any length of time for each of the three grace periods; “Sanitary Patient Re-contact”, “Extended Time Away”,
and “After Leaving Patient”.
Set to Factory Default Button is used to return all of the Badges in range of the Pod back to their factory
settings.
Badge Area
Badge Address
Badge Firmware
Revision
Badge Battery Level
Audio Volume
LED Brightness
Grace Periods
Set To Factory Default Button