User Manual

ProClenz DSP2000 Performance UltraClenz, LLC
Page 3
used to change the mode that the Pod is in by changing the range of the Pod’s RF transmitter. “Connect to
Dashboard” is used to reconnect to the Dashboard if communications are lost for any reason.
Under Help there is one selection “About” which gives information about the Application and the Pod.
2.2 Pod Control (see Figure 2)
This section consists of four buttons that are used to control the PSS Badge Configuration Pod.
Figure 2 Pod Control
The Connect button is used to reconnect to the Pod if communications between the Pod and PC are lost for any
reason. This button will display a green dot if the PC is connected to a Pod and a red “X” if the PC has lost
contact with the Pod. If the red “X” is displayed, the remaining buttons will be disabled and the pictures will no
longer be visible.
The Scan button is used to update the list of Badges in the “Badge Control”. The Application will then display the
first twenty (20) Badges that are in range of the Pod.
The Read button is used to retrieve the configuration of a specific Badge. This button will be disabled until a
Badge is selected in the “Badge Control”.
The Save button is used to give all of the Badges in range of the Pod the configuration selected in the “Badge
Settings.” Clicking this button also causes the Application to check the three grace periods for consistency before
sending the new configuration to the Badges.
2.3 Badge Control (see Figure 3)
The Badge Control consists of a list box that contains the addresses of the Badges found in the last scan.
Displayed in this box are the addresses of the Badges, their firmware revision numbers, and the battery level
percentage of each Badge. The Application can display the information of up to twenty (20) Badges. A single
Badge can be selected by clicking on its address. This will enable the “Read Button” in the “Pod Control” and will
also populate the “Badge Address” displayed in the “Healthcare Worker’s Information.” Selecting a Badge will also
enable the “Read From Dashboard” button.
Connect Button
Read Button
Scan Button
Save Button