User Manual

DFU Document Title Here
4. Power-
On Self Test Sequence
When batteries are installed in the
PSS Door Monitor
LED, single flash red LED, single flash green LED, single flash red LED,
5. Entry-
Exit Functional Sequences
Door Entry (Compliant)
• Activate the hand s
anitizer dispenser
• The PSS Door Monitor
will flash one green
• Enter room
Door Exit (Compliant)
• Exit the room
• PSS Door Monitor red LED will flas
h
• Activate the hand sanitizer
• The green LED will flash once
6. RS485 to Host Computer
The USB to RS485 Network
Interface Kit (part number FAS1502
computer. (See Figures 3 and 5 for the location of the
7.
Changing the PIR Sensor’s Position
The PIR Sensor can be swapped from the right
(See Figures 6, 7and 8)
On Self Test Sequence
PSS Door Monitor
, a power on self test sequence initiates as follows: single flash green
LED, single flash red LED, single flash green LED, single flash red LED,
and three audible alarm beeps.
Exit Functional Sequences
anitizer dispenser
will flash one green
LED
h
Interface Kit (part number FAS1502
-00) is used to connect the
PSS Door Monitor
computer. (See Figures 3 and 5 for the location of the
RS485 connector)
Figure 5. RS485 Din Connector
Changing the PIR Sensor’s Position
The PIR Sensor can be swapped from the right
side to the left
side depending on the door opening configuration.
Figure 6. Right Side PIR
RS485 DIN Connector
UltraClenz, LLC
Page 9
, a power on self test sequence initiates as follows: single flash green
and three audible alarm beeps.
PSS Door Monitor
to the Host
side depending on the door opening configuration.
RS485 DIN Connector