User Manual

DFU Document Title Here
3. PSS Door Monitor
Configuration Software
The PSS Door Monitor
Configuration Software is a graphical user interface (
hardware and software parameters for
room layouts.
Before installing the
PSS Door Monitor
RS485 to USB serial
Interface driver. The RS485 to USB Network Interface kit (part number FAS1502
interface, driver CD, 2 communication cables and
computer’s USB port.
The second cable connects the
port DIN connector (
See Figure 3 for the Communication Port locations).
Figure 3.
3.1 PSS Door Monitor
Configuration Software
File
Exit - Closes the PSS Door Monitor
Configuration Software
Setup
Scan for COM Port -
Note, the PSS Door Monitor must be connected to the host PC
port until the PSS Door Monitor is found.
Tools
Reset Counts -
Reset all counts to zero
appear, to prevent inadvertent resets.
To
Configuration Software
Configuration Software is a graphical user interface (
GUI), which allows the installer to set
hardware and software parameters for
desired operation. The PSS Door Monitor
can be configured for a variety of
PSS Door Monitor
Configuration Software on the Host computer, the u
ser must first install the
Interface driver. The RS485 to USB Network Interface kit (part number FAS1502
interface, driver CD, 2 communication cables and
users guide. The first cable connects the
serial
The second cable connects the
serial Interface to the PSS Door Monitor
’s
See Figure 3 for the Communication Port locations).
Figure 3.
USB to RS485 Converter Cable Connection
Configuration Software
Menu (See Figure.4)
Configuration Software
Note, the PSS Door Monitor must be connected to the host PC
.
The software will scan each COM
port until the PSS Door Monitor is found.
Reset all counts to zero
. A confirmation message "Do you r
eally want to set the counts to zero" will
RS485 D
IN
Connector & Cable
To
Commputer’s USB Port
UltraClenz, LLC
Page 6
GUI), which allows the installer to set
-up the
can be configured for a variety of
ser must first install the
Interface driver. The RS485 to USB Network Interface kit (part number FAS1502
-00) includes the
serial
Interface to the host
’s
RS485 communications
The software will scan each COM
eally want to set the counts to zero" will