User Manual

Patient Safeguard System – Bed Beacon User’s Guide UltraClenz, LLC

Page 12

Appendix A - System Component Care and Maintenance

Cleaning the Components

The bed beacon should be cleaned by wiping with a soft cloth. A mixture of 90% water and 10% chlorine (bleach)

or water and mild detergent (dish soap) may be used. The cloth should be damp but not wet. Only the exterior of

the component may be cleaned. Do not attempt to clean any interior surface of this component as this will

damage the component’s circuitry. Do not use abrasive cleaners or cleaning products in aerosol cans as they will

damage the component’s finish.

Handling the Bed Beacon

The bed beacon is an electronic device and should be handled with care. Like other electronic devices such as

cell phones, the bed beacon must be protected from extreme heat, cold and moisture. Avoid handling the bed

beacon with wet hands or exposing it to rain. Avoid dropping or tossing the bed beacon. The shock can damage

the beacon’s sensitive internal electronics.

Battery Replacement