User Manual

Patient Safeguard System – Healthcare Worker Badge User’s Guide UltraClenz, LLC
Page 9
Appendix A - System Component Care and Maintenance
Cleaning the Components
The badge, bed beacon and dispenser beacon should be cleaned by wiping with a soft cloth. A mixture of 90%
water and 10% chlorine (bleach) or water and mild detergent (dish soap) may be used. The cloth should be damp
but not wet. Only the exterior of each component may be cleaned. Do not attempt to clean any interior surface of
a component as this will damage the component’s circuitry. Do not use abrasive cleaners or cleaning products in
aerosol cans as they will damage the component’s finish.
Handling the Badge
The badge is an electronic device and should be handled with care. Like other electronic devices such as a cell
phone, the badge must be protected from extreme heat, cold and moisture. Avoid handling the badge with wet
hands or exposing it to rain. Avoid dropping or tossing the badge. The shock can damage the badge’s sensitive
internal electronics.