User Manual

Document Title UltraClenz, LLC
Page 7
Step 2 – Connect Ethernet Cable to Router
Take the RJ-45 connector of the other end of a category 5e Ethernet cable and insert it into the Ethernet port on
the router. (see Figure 5).
The finished assembly should resemble Figure 6.
Configuring the Gateway
Configuring the Gateway requires a third party terminal emulation program. For the purposes of this manual, we
will use HyperTerminal by Microsoft. To connect the Gateway to the PC you will need a USB to RS485 Network
Interface Kit (KIT1101-00), available from UltraClenz. For instruction on how to install and configure the USB to
RS485 Network Interface Kit, please refer to DOC1000r0.
Figure 5
Figure 6