User Manual

Document Title UltraClenz, LLC
Page 6
Step 2 – Inserting the Power Supply Wires
With the small flat-tip screwdriver in place, insert the wire with the white stripe on it from the power supply
(positive wire) (see Figure 3) into the circular opening directly beneath the rectangular slot until it stops and pull
out the small flat-tip screwdriver to lock the wire in place. Give the positive wire a slight tug to insure that it is
locked into place. Repeat the process for the rectangular slot of the power connector marked - (negative) on the
back of the hub with the remaining wire.
Note: Please ensure proper polarity before plugging the power supply into an electrical outlet.
Connecting the Gateway to a Router
The WiNet Gateway is designed to work with any router that will provide Internet access. For the purposes of this
manual, we will use the Cradlepoint CBA250 Cellular Broadband Adapter. For instructions specific to your
equipment, please consult the manufacturer’s users’ guide.
Step 1 – Connect Ethernet Cable to Gateway
Place the RJ-45 connector of one end of a category 5e Ethernet cable and insert it into the Ethernet port on the
back of the gateway (see Figure 4).
Figure 3
Figure 4