User Manual

Document Title UltraClenz, LLC
Page 5
Installing the Hub
This procedure will require a small hammer, drill, drill bits, level and a screw driver.
Step 1 – Positioning the Chassis
Place the leveled WiNet Hub on the mounting location to transfer the drill centers.
Step 2 – Drilling the Holes
Drill 2 holes with the proper bit. Use standard bits for dry wall and masonry bits for tile applications.
Step 3 – Placing the Anchors
Gently tap the anchors in place using a hammer.
Step 4 – Mount the Tag to the Wall
Screw the WiNet Hub tightly to the wall.
Connecting the Hub to the Power Supply
This procedure will require a small flat-tip screwdriver.
Step 1 – Inserting the Screwdriver
Insert a small flat-tip screwdriver into the rectangular slot of the power connector marked + (positive) on the back
of the hub (see Figure 2). With the tip of the small flat-tip screwdriver, depress the metal tab.
Figure 2