User Manual

Document Title UltraClenz, LLC
Page 6
Installing the Tag
This procedure will require no tools.
Step 1 – Tag Mounting Location
In a dry indoor environment, locate an area on a wall next to the dispenser where the Tag will be mounted,
preferably to the immediate right or left of the dispenser. Make sure the wall’s surface is clean and free of dirt,
dust or grease.
NOTE: The Tag is a radio and therefore should not be mounted on or near large metal objects. Doing so may
degrade its performance.
Step 2 – Attach the Cable to the Tag
Insert one end of the detachable cable into the port on the back of the Tag (see Figure 5).
Figure 5
Step 3 – Fold Cable
Make a 90 fold in the cable at the recessed portion of the back of the enclosure (see Figure 6).
Figure 6
If the Tag will be mounted on the left side of the dispenser, fold the cable to the left. If the Tag will be mounted on
the right side of the dispenser, fold the cable to the right.
Step 4 – Mount the Tag to the Wall
Unpeel the protective layer from the two pieces of double sided tape that are located on the back of the Tag.
Align the top of the Tag with the top of the dispenser and press the Tag firmly against the wall.