User Manual

Document Title UltraClenz, LLC
Page 5
Installing the Batteries
This procedure will require a small Phillips screwdriver.
Step 1 – Open Tag Enclosure
With a small Phillips screwdriver, remove the two screws located on the front of the Tag enclosure (see Figure 2).
With the screw removed, separate the bottom half of the Tag enclosure from the top half. The Tag will be
secured inside the Tag enclosure.
Figure 2 – Location of Screws
Step 2 – Removing Battery Insulators (Batteries preinstalled)
Depending on the configuration ordered, batteries may be preinstalled in the Tag. To prevent power drainage
during shipping, insulators may be inserted between the battery contacts and the battery (see figure 3). Remove
the battery insulators by gently pulling the insulation away from the battery.
Step 3 – Installing New Batteries (Batteries not preinstalled)
Depending on the configuration ordered, batteries may not be preinstalled in the Tag. Insert a coin cell battery
(CR2430) into the battery holder with the positive (+) side facing toward the contact (see figure 4). Repeat the
procedure for the remaining battery holder.
Figure 3
Figure 4