User Manual

Document Title UltraClenz, LLC
Page 10
09520009 = Gateway assigned to that network
Maintenance
Cleaning
The exterior can be cleaned with a NON abrasive detergent and a NON abrasive damp (not wet) sponge or cloth.
The Tag is splash resistant but not water proof.
Changing the Batteries
This procedure will require a small Phillips screwdriver and two (2) coin cell batteries (CR2430).
Step 1 – Open Tag Enclosure
With a small Phillips screwdriver, remove the two screws located on the front of the Tag (see Figure 2). With the
screw removed, separate the bottom half of the Tag enclosure from the top half. The Tag will be secured inside
the Tag enclosure.
Step 2 – Replacing Old Batteries
Remove the old batteries by carefully sliding them out of the battery holders. Inset a coin cell battery (CR2430)
into each of the battery holders with the positive (+) side facing toward the contact (see figure 4).