Installation Instructions

48
1. Installation
1.1 Step 1: Bed Mode Configuration
Install 2 Duracell Coppertop alkaline D cell batteries into the Bed Beacon. The Bed Beacon needs to be
configured to stretcher mode before installing the Bed Beacon onto the stretcher. To get the Bed Beacon
into stretcher mode, hold both range buttons down. Immediately, the Bed Beacon will alternate 4 times
between green and red flashes with each flash there will be an audio alert. Two (2) seconds later, the Bed
Beacon should flash red and beep twice. The two red flashes and audio alert confirms that the Bed Beacon
is set for stretcher mode. If there is one (1) green LED flash and one (1) beep, the Bed Beacon was already
in stretcher mode and is now in bed mode. Repeat the process to get the Bed Beacon back into stretcher
mode.