Installation Instructions

36
AC Line Power Sensor
attached to power cord
2. Plug the patient bed’s AC power cord into a 120vAC power source. This will activate the Bed Beacon so
that the range setting and all testing can be performed. Refer to section 6 - Adjusting the Patient Zone in the
main section of this document for instructions on adjusting the communication range.
2. Cable Management
2.1 Step 5: AC Line Power Sensor Cable Routing
1. Place cable tie holders, cable ties and route AC Line Power Sensor cable to the Bed Beacon as shown
(see Figure 4 & 5). Make sure the mounting surfaces are clean and free of dirt and oil. A soft cloth
dampened with isopropyl alcohol works well to clean mounting surfaces.
2. Route the AC Line Power Sensor cable underneath the headboard along the metal rail frame. Secure the
cable with cable ties shown in Figure 4 & 5.
Figure 3. Connecting the
AC Line
Power Sensor
to the
Bed Beacon
via the RJ11 connector
Figure 4.
AC Line Power Sensor
Cable Routing to the
Bed Beacon
Cable
Ties
Cable
Ties