Installation Instructions

AC Line Power

Sensor attached to

power cord

1.4 Step 4: Adjusting the Bed Beacon to Proper Field Range

1. Connect the AC Line Power Sensor to the Bed Beacon via any RJ11 jack as shown in Figure 3.

2. Plug the patient bed’s AC power cord into a 120vAC power source. This will activate the Bed Beacon so

that the range setting and all testing can be performed. Refer to section 6 - Adjusting the Patient Zone in the

main section of this document for instructions on adjusting the communication range.

2. Cable Management

2.1 Step 5: AC Line Power Sensor Cable Routing

1. Place cable tie holders, cable ties and route AC Line Power Sensor cable to the Bed Beacon as shown

(see Figure 4 & 5). Make sure the mounting surfaces are clean and free of dirt and oil. A soft cloth

dampened with isopropyl alcohol works well to clean mounting surfaces.

Figure 3.

Connecting the

AC Line Power Sensor

to the

Bed Beacon

via the RJ11 connector

Figure 4.

AC Line Power Sensor

Cable Routing to the

Bed Beacon

AC Line Power Sensor

Cable RJ11 Connectors

Cable Tie

Holders