Installation Instructions

23
Appendix D- Z Bracket (9205-2236)
The Z Bracket (see Figure 1) is an optional mounting brace for the Bed Beacon to be mounted onto the
VersaCare model bed. The Z Bracket helps to elevate the Bed Beacon from the ground when the bed is at its
lowest point.
Mounting
Mount the Z Bracket under the bed on the metal surface shown in Figure 2 with double-sided tape and cable tie.
Make sure the mounting surface is clean and free of dirt and oil. First, spray a mixture of liquid dish soap (1% of
soap per gallon of water) and scrub the mounting surface with a plain Scotch-Brite scouring pad. Wipe the surface
with a lint free cloth to clean off any contaminants. Second, use a soft cloth dampened with isopropyl alcohol to
further clean the mounting surface. Repeat the process as necessary. Ensure the mounting surface is dry before
attaching the Z Bracket and firmly push and hold in place for several minutes (see Figure 2). Once the Z Bracket
is firmly mounted, secure the Bracket by cable tying it to the bed frame (see Figure 2), use small wire cutters to
carefully flush cut off and dispose of all cable tie ends. Finally, place the Bed Beacon onto the Z Bracket as
shown in Figure 2 with double-sided tape.
Figure 1.
Z Bracket
Figure 2.
Mounting the
Z
Bracket
Cable Tie
Bed Beacon