Installation Instructions

10
through the operation modes, until you reach five (5) red LED flashes / 5 audible beeps. Release the range
buttons to set.
3.6 Stretcher Mode Using Internal and External Antenna Mode (toggling back and
forth between the internal and external antenna)
****** 6 red flashes and beeps – operation mode 6
“Stretcher Mode using Internal and External Antenna” is used when the Bed Beacon and the External
Antenna ( Ecolab P/N: 92052232 ) are mounted directly under a patient stretcher and there is no AC Line
Power Sensor connected to it. In this stretcher mode, the Bed Beacon will always have the Patient Zone
“on”. In this mode the patient zone is created alternatingly by the External Antenna and the Bed Beacon’s
internal antenna. This is used to extend the effective area of the patient zone. To set the mode, press and
hold both range buttons down. Immediately, the Beacon will flash three (3) times the green LED. With each
flash, there will be an audible alert (beep). Continue to hold the range buttons down while the bed beacon
continues to cycle through the operation modes, until you reach six (6) red LED flashes / 6 audible beeps.
Release the range buttons to set.
4. Installation
4.1 Mounting Bracket 9205-2337 Installation - Patient Bed
The Mounting Bracket can be mounted in the center of the lower bed frame (see Figure 3).
Figure 3. Mounting Bracket on Patient Bed Model Hill-Rom Versa Care P3200
Make sure the Mounting Bracket location surface is clean and free of dirt and oil. Spray a mixture of liquid
dish soap (1% soap per gallon of water) and scrub the mounting surface with a plain Scotch-Brite scouring
pad. Wipe the surface with a lint-free cloth to clean off any contaminants. Next, use a soft cloth dampened
with isopropyl alcohol to further clean the mounting surface. Repeat the process as necessary. Ensure that
the mounting surface is dry before attaching the Mounting Bracket. Peel off the double-sided tape liner on
the Mounting Bracket. Firmly press and hold the Mounting Bracket in place for several minutes. Secure
the Mounting Bracket with the two (2) 14 inch long cable ties, one (1) on each side of the Bracket. Finally,
flush cut off the excess cable tie ends.
2- 14” Long
Cable Ties