Use and Care Manual

OPERATING INSTRUCTION
Check before turning on the machine
1. Check if the power wire is under good condition.
2. The product adopts 120V AC power supply, before use, please confirm if
the rated current of the power socket meets the local requirements with safe
grounding device, otherwise, please replace it with the qualified socket.
Start the machine
Plug the unit into a grounded 120V outlet, the power light" "on, press the
ON/OFF key (or press the ON/OFF key of the remote controller) for start, the
machine supplies air at high power after start, the digital screen displays "HI".
Function setting
Repeatedly press the "Function" key so that the heater switches in the order of
"high gear - low gear - ECO mode - high gear".
Temperature setting
In the ECO mode of the machine, press "+" or "-" can set the temperature value,
set the range of 5-35
℃.When the room temperature exceeds the set temperature
at 2
℃, the display flashes 10s, the machine stops working, and stay in the standby
state. When the temperature is lower than the set temperature, the machine starts to
heat up again.
Timing function
Timing stop
When the heater is turned on, press the TIMER key to enter the timing stop state
(within 0-8 hours), then press the "+" key to increase the timing stop time ,
and press the "-" key to decrease the timing stop time.
Timing start
When the electric heater is in the standby mode, press the TIMER key to enter the
reservation start mode (within 0-8 hours), then press the "+" key to increase the
reservation start time , and press the "-" key to decrease the reservation start time .
Dispaly area
Swing Timer -, + Function ON/OFF
3