User Manual

User and installer's manual

Figure 4.2. AP-WiFi mode connection scheme. Direct access by WiFi (example).

NOTE

▪ The wireless network generated by the GATEWAY does not have an internet connection.

▪ Some devices, such as mobile phones, can block access to networks that do not have an internet

connection. Check your device's settings to allow connection to networks that do not have an internet

connection.

▪ Access to the web interface is only possible within the range of the wireless signal generated by the

GATEWAY. Approximately 50 meters in an obstacle-free area.

4.3. LAN-ETHERNET mode

This lets you access the ECOFOREST device from your device (mobile phone, tablet, PC, etc.) by means of a connection through your

local area network, using an Ethernet cable connection between your router and the EASYNET GATEWAY. To make this type of

connection, follow the steps below:

1. Connect the EASYNET GATEWAY to your router using an Ethernet cable.

2. Access the EASYNET web interface through the my.ecoforest.com portal from a device that has an Internet connection and

select the desired access type. See section 5.

Figure 4.3. LAN-ETHERNET mode connection scheme. Access through the local network (example).

AP WiFi

GATEWAY

EASYNET

GATEWAY

EASYNET

ETHERNET