Installation Guide

VERSION: V2.1REVISION: 11/05/21
INSTALLATION
PAGE
04
SIMPLESEAL
INSTALLATION GUIDE
Pre-install the cone-shaped rubber
SimpleSeal EPDM bushing into an
EcoFasten compression bracket of
your choice prior to installation by
inserting the tip of the cone into the
corresponding shape in the bottom
of the compression bracket. The
ridge around the tip of the cone will
hold the bushing in place until the
bracket is installed.
Place the compression bracket on
roof surface above a supporting
structural component, ensuring
that the bushing sits at against
the roof surface. SimpleSeal is not
designed to be installed on any
ridge or corrugation of the metal
roof surface.
INSTALLING SIMPLESEAL