Installation Guide
VERSION: V2.1REVISION: 11/05/21
SPECIFICATIONS
PAGE
12
4141 W. VAN BUREN ST, SUITE 2, PHOENIX AZ 85009
1 - 8 7 7 - 8 5 9 - 3 9 4 7 | INFO@ECOFASTENSOLAR.COM
SIMPLESEAL
INSTALLATION GUIDE
DESIGN REQUIREMENTS
1. Bracket spacing to be recommended by project engineer.
2. Fasten attachment to roof using 1 5/16" lag bolt.
3. It is important to design new structures or assess existing structures to
make sure they withstand retained loads.
EXAMINATION
1. Substrate: Inspect structure on which brackets are to be installed and verify
that it will withstand any additional loading that may be incurred.
2. Notify General Contractor of any deciencies before installing EcoFasten
Solar brackets.
3. Verify that roong material has been installed correctly prior to installing
solar attachment bracket.
INSTALLATION
Comply with architectural drawings and project engineer’s recommendation for
location of system. Comply with Manufacturer’s written installation instructions for
installation and layout.