TDS

 ASTM E96: - Meets typical water vapor transmissions for “Flat” latex paint
 ASTM E84 – To be fire resistant with the highest rating available: Flame Spread of “0”, Smoke
Developed “0” NFPA/BC Class A Coating.
Recommended Use
Use to seal and treat lead paint/dust as a self-priming interior paint, to prep surfaces for most topical
coverings or as an exterior primer prior to application of standard exterior topcoats. Ideal for home, office and
commercial facilities. Superior adhesion on most properly prepared substrates. The unique Paint It On, Leave
It On formula® can be used on a variety of surfaces including but not limited to: wood, drywall/plaster, steel,
masonry, brick, metal, concrete and asphalt.
Coverage
250-300 sf/gl depending on surface texture, porosity and application method.
Note: Recommended film thickness for single coat is 4-6 mil wet for typical application.
Additional layers may be required for higher concentrations of lead.
Drying Times (@70-77°F, 50% RH)
To the Touch – 2-4 Hours
To Recoat/Topcoat – 4 Hours
Note: High humidity, low temperatures and poor ventilation will affect dry times.
Recommended Application Tools
 Airless Sprayer: Recommended tip size .017 - .031
 Roller: High quality 1/2” – 3/4” nap
 Brush: Nylon/Polyester blend
Mixing
Mix thoroughly for 1-3 minutes. Prior to use, mechanically shake or mix with a drill powered paint mixer.
Application
 Apply when air and surface temperatures are between 50 and 100°F
 Thoroughly mix prior to use for 1-3 minutes with drill powered mixer or have mechanically shaken
 Initial testing is recommended by painting a small area prior to full application to confirm compatibility
 Apply as supplied using a sprayer, roller or brush
 Protect surface from rain or moisture until dry
Clean-up
Wash hands and tools with water. Clean up spills immediately with water.
Storage
Store in a dry place at temperatures between 40°F (4.5°C) and 90°F (32°C).
Disposal
Dispose of all waste in accordance too local, state and federal regulations.