User Manual

-9-
Step3: Install the panel on the roof
The picture below illustrates the correct way to use the well-nut. The
rubber flange has to be flushed on the roofline. The Z-Bracket, along
with the flat washer and lock washer, holds the well-nut in place when
the screw is fastened.
Gently insert the well-nut into the drilled hole. Be careful not to push the
well-nut flange completely into the holes. Make sure the flange is
flushed on the roofline. Before attaching the panel to the roof, a film of
caulk can be laid between the roof and the Z-Bracket. Even though the
well-nut provides a watertight bond, this provides additional sealant.