Technical information

Figure 8 Concentric Flue
Hold the appliance upright against the wall
at approximately. 5 cm above the place
where it will be mounted. Press the
appliance into the guides and carefully allow
it slide downward, so that the hook on the
support bracket falls in the opening at the
back of the appliance and the pins below
the appliance drop into the corresponding
openings in the support bracket.
The connections on the appliance will then
mate up with the connection points on the
support bracket.
14.10 Connections
Gas and water tighten the gland nuts on
each of the connections (1) to (5) firmly.
15. Flues and Ventilation
The internal boiler flue system is
manufactured stainless steel and the flue
outlet may be connected to an external
P.P.S plastic or stainless steel flue system.
15.1 Maximum Flue Lengths
The flue materials, flue insulation, the
amount of vertical and horizontal pipe and
the amount of bends incorporated
determine the maximum permissible flue
length.
The excess fan pressure available for
overcoming the frictional resistance of the
flue system is 185 p.a.
Page 20
ECO HOMETEC
(
UK
)
LTD
.