Installation & Assembly

Page 7 of 9
2. Glass Holding Brackets
a. Place the glass holding brackets ‘D’ into
position.
b. Fix them into place using a washer, the
socket cap recessed hex screws ‘E’ and
the Allen key included with the unit. The
glass holding brackets can be adjusted
to ensure the glass sits perfectly vertical.
3. Burner Installation
a. Place the burner rack into position.
(Some models already have the burner
rack in position)
b. Place the burner ‘F’ into the overflow
container ‘G’ as shown in the illustration.
Make sure the control arms ‘H’ go
through the shutter plate holes ‘J’ on either
side when placing the burner into the
overflow.
c. Remove the handle ‘K’ by
unscrewing it. Carefully place the
over-flow container and burner into the
designated slot in the burner rack.