Instruction manual

ENGLISH
Instruction manual MECHANIKA · TECHNIKA
24
4.1 Preparation for installation
• Place the machine on an even and stable surface.
• Never place the machine on hot surfaces.
4.2 Electrical connection
• Make sure that the local main supply voltage corresponds to the information given on the type
plate on the front panel of the espresso machine.
• Plug the machine into a grounded socket only and do not leave it unattended.
• Do not roll or bend the power cord.
• Do not use an extension cord/ do not use a multiple socket.
4.3 Water supply connection
Important
Make sure that the water supply installation of the machine is connected to a potable water supply
with an operating pressure ranging from 0 to 1.5 bar. In case of an operating pressure of more than
2 bars use a pressure regulator.
Please note that often the pressure of the water supply varies. If the water supply pressure temporarily
exceeds 1.5 bar, use a pressure regulator.
Position “0”: water tank Position “1”: direct water connection
Machine in use with direct water connection
The water connecting hose is to be connected to the water supply adapter (image 1).
When using the machine with direct water supply, the valve has to be turned to the side of the water supply adapter
(image 1). The water supply adapter is located in the rear part of the bottom panel (image 1). Additionally, place the
switch behind the drip tray into position “1” (image 2). Please make sure that your water tap is always open during
water-connection usage so that the machine never runs out of water!
image 1 image 2
Valve in position for operating
machine with direct water connection
(facing towards the back side of the
machine)
Place switch into position “1” for
direct water connection
Water supply adapter
Important
Do not leave the machine connected when not in use.
Make sure to close the lock valve of the water connection and to switch off the electric main switch or
to disconnect the power plug when the machine is not in use.