Operation Manual
Bedienungsanleitung / User Manual SYNCHRONIKA
ENGLISH
25
4 Please wait until the desired coffee-, i.e. steam temperature, has been reached (value indicated on the PID-
display).
5 In general, the machine will be heated up in about 15 minutes, depending on the ambient temperature.
6 The machine is now ready for use.
7 Prior to preparing your first coffee, insert the filter holder and activate the brew lever in order to release hot
water and to heat the filter holder to an optimal temperature.
Machine in use with direct water connection
1 Please make sure that there is always water pressure in the water connection line (indicated on the pump
pressure gauge).
2 Now turn the machine on (the metal switch in the upper position and the right switch behind the drip tray in
position ‘1’).
To use the steam function, press the right switch behind the drip tray in position ‘I’ (image 3, page 23).
3 Wait until the gauge indicates a value of 1.0 – 1.5 bars.
4 In general, the machine will be heated up in about 15 minutes, depending on the ambient temperature.
5 The machine is now ready to use.
6 Prior to preparing your first coffee, insert the filter holder and activate the brew lever in order to release hot
water and heat the filter holder to an optimal temperature.
It is recommended to leave the filter holder in the brew group, keeping it warm for optimum
temperature for coffee dispension.
If you would like to plumb your machine, installation through a qualified service technician is
required.
6.2 Programming the temperature via the PID-display
During normal operations, the temperatures of the coffee boiler (t1, left dot on the display) and the steam boiler (t2,
right dot on the display) are indicated alternately.
The controls are factory pre-set so that both boilers are heated consecutively, whereby the coffee boiler (t1) has
priority. This means that the steam boiler (t2) is activated only after the programmed temperature of the coffee
boiler has been reached.
The machine can also be set up by your specialist dealer so that both boilers can heat at the same time.
Switch the machine on in order to activate both boilers (switch in position “2”).
The temperature of either boiler is of no importance in programming. Both
heaters are inactive during programming.
2. Press
+
and
–
at the same time until ‘t1’ (coffee boiler) appears on the
display,
3. Press
+
in order to progress to the submenu of ‘t1’ and to change the
temperature value. The nominal temperature value is displayed.
4. Quickly press
-
to decrease
+
to increase
the nominal temperature value.