Operation Manual

ENGLISH
Instruction manual ELEKTRONIKA PROFI
24
1 Place an adequate water container (with a heat-insulating handle) under the hot water dispenser. After having
moved the power switch in lower position, you can dispense water (e. g. for tea) by opening the hot water lever.
2 After dispensing water, switch the machine on again. The boiler will be filled with fresh water automatically.
When the machine is switched off, more hot water can be dispensed.
However, one does not necessarily have to switch off the machine for dispensing water.
Caution!
Place the nozzle of the dispenser into the water container in order to avoid injuries due to hot water
spillings.
6.4 Dispensing steam
With the Elektronika Profi, you can generate a large amount of steam in order to heat or froth beverages, e. g. milk
or punch. It is a professional and compact espresso coffee machine with an enormous steam volume. Therfore,
within a few seconds you can prepare milk froth. Please pay attention to the instructions noted below. Do not bring
the milk to a boil, otherwise frothing milk will not be possible.
1 Important: In order to get the best result when frothing the milk, open the steam lever for approx. 5 seconds to
release the condensation water in the pipe.
2 Immerse the steam nozzle (at the end of the steam dispenser) in the liquid.
3 Re-open the steam handle / steam lever.
4 Heat and/or forth the liquid.
5 After frothing or heating, release the steam into the drip tray to keep the slots of the steam nozzle clean.
Risk of injury!
Always keep the steam nozzle underneath the surface of the liquid while heating or frothing to avoid
spillings.
Important!
Clean the steam nozzle and the steam dispenser after every application with a non abrasive damp
cloth; this you can remove possible liquid residues.
Risk of injury!
Avoid skin contact with the steam dispenser while cleaning!
7 CLEANING AND MAINTENANCE
A regular and accurate care is very important for the performance, the long lifetime and the safety of your machine.
Caution!
Always switch off the machine (power switch in lower position), disconnect the power cord and let the
machine cool down to ambient temperature (for at least 30 minutes) before cleaning.
7.1 General cleaning
Daily cleaning:
Filter holder, filters, water tank, drip tray, drip plate of the drip tray, measuring-spoon and tamper require daily
cleaning. Use warm water and/or with food safe detergent for cleaning.
Clean the shower and the group gasket in the lower part of the group and remove visible dirt without dissasembling
the parts.
Cleaning as necessary: