Operation Manual

ENGLISH
Instruction manual ELEKTRONIKA PROFI
22
6 The pump starts to work and fills the boiler with fresh water.
7 As soon as the filling of the boiler, no pumpe noise is hearable anymore and the control panel lights up.
8 Water tank machines: As soon as the fresh water in the water tank drops to a certain level, the machine is
switched off automatically and the buttons of the control panel flash. Refill fresh water into the water tank. The
machine will heat up automatically.
In case the machine does not heat up automatically, briefly switch off the machine. Then switch
it on again.
9 Water tank machines: As a large amount of water is required for the first filling of the boiler, refill the water tank
with fresh water.
10 Wait until the boiler pressure gauge indicated approx. 1.0-1.2 bar.
11 A manual “boiler ventilation” is not necessary because the Elektronika Profi is equipped with a professional
despression valve that ventilates the boiler in the heat-up phase.
12 Press the star key and dispense approx. 250 ml. Thus, the heat exchanger ist filled and the water circulation in
the thermosyphon system begins.
13 Press the star key again to end the water outlet from the brewing group.
14 Water tank machines: Refill the water tank.
15 The machine is now ready for use. Place the cups on the cup heater tray in order to preheat them.
5.2 Dose programming
To program the doses proceed as follows:
1 Choose a filter holder and fill it with the suitable quantity of coffee according to the button you would like to
program (e. g. filter 1 cup for filter holder 1 cup: 7g coffee, button no. 1). Place a cup under the filter holder.
2 Press the star key and keep it pressed until it flashes.
3 Choose the button you would like to program and press it shortly. Coffee is released into the cup.
4 As soon as the desired quantity of coffee is reached, press the button again. Thus, the dose for the chosen
button has been programmed.
• Please note that the doses can vary if different quantities of coffee are used for coffee preparation
or if the imposed pressure on the coffee is different while tamping.
• Every button can be reprogrammed at any time.
Reset function:
With the reset function possible failures can be resolved (e.g.if the machines does not heat up etc.). To reset the
machine press button 1 and 2 at the same time. Thus, the machine will be restarted.