Owner`s manual

ENGLISH
［4］Adjusting the speaker angle
①Using the hexagonal wrench, loosen the
hexagonal socket head bolts (3 places).
②Using the hexagonal wrench, turn the angle
adjustment screw.
③When finished, use the hexagonal wrench to
tighten the hexagonal socket head bolts.
To secure the speaker, first tighten the two rear
bolts, then tighten the front bolt.
Upward adjustment
Angle adjustment
screw
⑥Hexagonal wrench
When the top surface of the stand and the
bottom surface of the speaker are flush, they
should be level. It is possible to adjust the
speaker upwards by 10 degrees.
ADVICE
［3］Setting the angle adjustment screw at 0 degrees
①Cut out the template on page 61 and discard
the portion not required.
Template
②Turn the speaker base upside down and
adjust the angle adjustment screw to a
height matching the gauge as shown in the
diagram. At this point, the angle is set at 0
degrees.
Angle adjustment screw
Template
When adjusting the speaker angle, follow these
instructions and start from a 0 degrees position.
ADVICE
−17−