MODEL CH3083 8 - DISC CD CHANGER OWNER'S MANUAL We appreciate your purchase of this product. Please read through this manual for correct operation. We suggest that after reading it you keep this manual in a safe place for future reference.
For your safety in using the CH3083 Warnings and caution signs, illustrated below, are posted throughout this manual as well as on the CH3083. They show safe and correct ways to handle the product so as to prevent personal injury to you and others and avoid damage to property. Before reading through the manual, take time to read through and learn the important information listed in this section.
Warning • Do not place the vinyl storage bag over a person. It may cause a serious accident or death by suffocation. • Do not disassemble or rebuild this product. Doing so may cause an accident, fire or electrical shock. • When it is necessary to replace the fuse, always use a fuse of the correct rating (number of amperes). Use of fuses with higher amperage ratings may cause a fire. • Do not operate the product in a malfunctioning condition, for instance, when the audio does not play.
Warning • To prevent a short circuit from occuring, disconnect the battery's negative terminal before installing this product. Otherwise, an electric shock or injury may result • When using an existing nut and/or bolt from the vehicle to ground this product, do not use any that secure parts of the steering or braking systems. Otherwise, an accident may results. • Bundle cables and harnesses with electrical tape or wire ties to prevent them from interfering with moving parts.
Caution • Play the audio at a moderate volume level that permits you to hear sounds from outside the car. Driving without being able to hear outside sounds may result in an accident. • Keep foreign objects out of the disc slot. They may cause fire or electrical shock. Another possibility is that discs may be damaged or become stuck. • Do not stick your fingers or hands into the CD changer magazine slot. Doing so may cause personal injury.
Caution • Do not install this product in locations where it cannot be fastened securely, such as places subject to frequent vibration. Otherwise, it may become dislodged and cause an accident or injury. • If this product is not connected properly, a short circuit, fire or accident may occur. • When routing cables, use care so that they do not contact sharp metal parts such as brackets or screw tips. Otherwise, a short circuit, electric shock, fire or accident may result.
Table of Contents Operating precautions ................................................ 8 Notes on operation ........................................................................ 8 About compact discs .................................................................... 9 About cleaning a CD ................................................................... 11 Preparation ................................................................ 12 How to place the disc into the CD magazine .....................
Operating precautions Operating precautions Your CH3083 will perform well over a long period of time through correct handling and care. Notes on operation • For your safety, play only at volume levels that allow outside sounds to be heard. • We recommend using with this player a disc with the logo shown to the left. • You can play music CDs(CD-R/CD-RW) on this player. Be sure to use discs that have been properly processed. • Depending on the editing equipment used, some discs may not play properly.
Operating precautions About compact discs • The signal recorded on a compact disc is read by a laser beam, so nothing touches the disc surface. A scratch on the recorded surface or a badly warped disc may cause deteriorated sound quality or intermittent playback. Observe the following precautions to ensure high quality sound performance: • Do not stick a piece of paper or tape on, nor write on or scratch either side of a disc. • Discs spin at a high speed inside the deck.
Operating precautions About brand new CDs • You may notice that some brand new discs are rough around the center hole or outside edge. Remove the rough edges with the side of a ballpoint pen, etc. Rough edges may prevent proper loading in the deck. Flakes from the rough edges may also stick to the recorded surface and interfere with playback. About CD accessories • Do not use accessories (stabilizers, protective seals, laser lens cleaners, etc.) sold for “improving sound performance” or “protecting CDs.
Operating precautions About borrowed CDs • Do not use a CD with glue or remnants of adhesive tape or labels. They may cause the CD to get stuck inside or damage the deck. About irregularly-shaped CDs • Specially-shaped CDs, like heart-shaped or octagonal CDs, cannot be played. Do not attempt to play them, even with an adapter, since they may damage the player. About cleaning a CD • Use a commercially available compact disc cleaner to clean a CD, wiping lightly from the center to the edge.
Preparation Preparation When you listen to a CD with this CD auto changer, please proceed as follows before playing the CD. ■ How to place the disc into the CD magazine 1 Unloading knob • Slide a tray out of the CD magazine. The magazine holds up to eight CDs. It is not necessary to fill all eight trays. Empty trays are ignored when played. 2 CD magazine Labeled side up • Place the CD on the tray with the labeled side facing up. 3 • Slide the tray completely back into the magazine.
Preparation ■ How to place the CD magazine into the changer 1 • Slide the CD changer door completely open to the left. H V AX mM 5m M4x 2 • Load the magazine into the CD changer in the direction of the arrow on the top of the magazine. H V AX mM 5m M4x NEVER insert coins, screw drivers or anything other than the magazine into the magazine slot. 3 • Slide the CD changer door to the right to close. H V AX mM 5m M4x Note: You cannot start playing unless the door is fuliy closed.
Preparation ■ How to eject the CD magazine 1 • Slide the CD changer door completely open to the left. H V AX mM 5m M4x 2 • press the eject button on the changer to eject the magazine. H V AX mM 5m M4x Note: The CD magazine will not be ejected if the door is not completely open. About CD MAGAZINE • Use only the specified CD magazine. • Up to eight trays (CDs) can fit in the CD magazine.
Specifications ◆ Specifications System Compact Disc Digital Audio System Decoding (D/A) 1bit dual D/A converter Dynamic range 95dB or more(1kHz) S/N (IHF-A.1kHz) 95dB Harmonic distortion ratio 0.01% at 1kHz Wow/flutter Below measurable limits Nominal output level 2.0V RMS (0dB) Line voltage DC 13.2V (11 to 16V) Current consumption about 1.8A max. and less than 600mA Dimensions (W x H x D) during play. 1 9 9 16 " x 2 31 64 " x 7 32 " (230 x 63 x 185mm) Weight 1.6kg (main unit), 0.
Before installation ◆ Before installation Notes Be sure to disconnect the vehicle battery's negative terminal before installing CD changer unit. ■ Components 16 No.
Before installation ■ Preliminary instruction Before CD changer unit installation, be sure to remove CAUTION LABEL and TAPE. Notes In the event that the unit requires shipping, re-insert the shipping screws through the caution tag template to help prevent potential damage that may be caused by shipping. 1 CAUTION LABEL CD CHANGER UNIT TAPE H V Fig.
Before installation ■ Daisy chain connection Another CH3083 CD changer can be connected directly to your CH3083 CD changer in daisy chain. Both of these CD changers can be connected through the control unit. Notes This switch is set to "H" before shipment.
Mounting instruction ◆ Mounting instruction ■ Horizonal instruction 1 . Make sure levers on each side of CD changer unit are in the "H" position. NOTE: This levers is set to "H" before shipment. 1 CD CHANGER H V M4x5mmMAX H V Fig.
Mounting instruction 2 . Secure the side brackets on each side of CD changer unit. 4 HEX BOLTS [x4] (4x8mm) H V 1 3 CD CHANGER UNIT SIDE BRACKETS [x2] Fig.3 Notes • Use the "LH" holes (2 places) at the left of the side bracket to install the unit. • Use the "RH" holes (2 places) at the right of the side bracket to install the unit.
Mounting instruction 3 . Lift the carpet, and choose the mounting location by placing the base bracket in a safe location. Remove the papers, then press the base bracket on the floor panel securely. LIFT THE CARPET 2 BASE BRACKET REMOVE THE PAPER 6 SELF-ADHESIVE PAD Fig.4 4 . Replace the carpet and cut x pattern thru carpet where the mounting bolts appear. (Fig.5) 5 . Push mounting bolts through a carpet. (Fig.6) SCREW CARPET CARPET Fig.5 Fig.
Mounting instruction 6 . Install CD changer unit to the base bracket with 4 nuts provided. Place caps over the mounting bolts. 5 7 NUTS [x4] (5mm) CAPS [x4] H V M4x 5m mM AX 1 CD CHANGER 2 BASE BRACKET Fig.
Mounting instruction ■ Vertical instruction 1 . Make sure levers on each side of CD changer unit are in the "V" position. V H M4x5mmMAX H V NOTE: This levers is set to "H" before shipment. 1 CD CHANGER Fig.
Mounting instruction 2 . Secure the side brackets on each side of CD changer unit. HEX BOLTS [x4] (4x8mm) H V 4 1 3 CD CHANGER SIDE BRACKETS [x2] Fig.9 Notes • Use the "V" holes (2 places) of the side bracket to install the unit.
Mounting instruction 3 . Lift the carpet, and choose the mounting location by placing the base bracket in a safe location. Remove the papers, then press the base bracket on the floor panel securely. LIFT THE CARPET 2 BASE BRACKET REMOVE THE PAPER 6 SELF-ADHESIVE PAD Fig.10 4 . Replace the carpet and cut x pattern thru carpet where the mounting bolts appear. (Fig.11) 5 . Push mounting bolts through a carpet. (Fig.12) SCREW CARPET CARPET Fig.11 Fig.
Mounting instruction 6 . Install CD changer unit to the base bracket with 4 nuts provided. Place caps over the mounting bolts. 5 H V CAPS [x4] 1 M4x5mmMAX 7 NUTS [x4] (5mm) CD CHANGER 2 BASE BRACKET Fig.13 ■ Connections Caution To prevent electrical damage to audio unit, be sure to ground chassis of external power amplifier to car's body. • The chassis of an add-on amplifier must be properly grounded to a nearest metal part of the car's body.
Mounting instruction ■ System ① NOTE: Adjust the external amplifier's input level. CD3413 MAIN UNIT CH3083 CD CHANGER ② CD3413 POWER AMP. MAIN UNIT CH3083 POWER AMP. CD CHANGER ③ CD3413 POWER AMP. MAIN UNIT CH3083 POWER AMP.
2P 13P CH3083 1) CD3413+CH3083 TO HEADLIGHT SWITCH (Illumination) TO POWER ANTENNA RELAY (Supply) TO ACC (Power Supply) TO BATTERY + 12V (Permanent Supply) TO GROUND TO TURN-ON LEAD OF EACH UNIT (Supply) DIGITAL OUT Black Black/White Orange/White Blue Red Yellow 13P White Gray Pink Purple/Black Purple Green/Black Green Gray/Black CELLULAR PHONE (For mute) ANTENNA PLUG White/Black 16P CH3413 REAR FRONT NON-FADER Mounting instruction
2P 13P CH3083 DIGITAL OUT White Green/Black Purple Orange/White Black/White Pink Purple/Black Green Gray Blue Black TO SIGNAL INPUT OF AUXILIARY POWER AMPLIFIER CELLULAR PHONE (For mute) INSULATE EACH WIRE WITH TAPE INSULATE EACH WIRE WITH TAPE ANTENNA PLUG White/Black 16P Gray/Black 13P CD3413 NON-FADER Red Yellow TO GROUND TO TURN-ON LEAD OF EACH UNIT (Supply) TO HEADLIGHT SWITCH (Illumination) TO POWER ANTENNA RELAY (Supply) TO ACC (Power Supply) TO BATTERY + 12V (Permanent
2P 13P (A) (B) DIGITAL OUT White Black Black/White Pink Purple/Black Orange/White Green/Black Green Gray/Black Gray Purple Red TO SIGNAL INPUT OF AUXILIARY POWER AMPLIFIER CELLULAR PHONE (For mute) INSULATE EACH WIRE WITH TAPE INSULATE EACH WIRE WITH TAPE ANTENNA PLUG White/Black 16P Blue TO GROUND TO TURN-ON LEAD OF EACH UNIT (Supply) TO HEADLIGHT SWITCH (Illumination) TO POWER ANTENNA RELAY (Supply) TO ACC (Power Supply) TO BATTERY + 12V (Permanent Supply) Yellow 13P N
CUSTOMER NOTICE Please retain this booklet and write in the serial number of your CH3083 for identification. The serial number is labeled or stamped on the chassis. Serial No. 090001-1433A700 0508(N.O.) DIVISION OF FUJITSU TEN CORP.
