Owner's Manual

Operation
Changing the reception
sensitivity for automatic
scanning
The main unit lets you select the reception
sensitivity to
be used for automatic scanning of
stations. The two sensitivity modes available for
this main unit are AUTO mode
and OX mode.
During automatic scanning, the
reception sensitivity switches
automatically
to one of two levels.
Initially the reception sensitivity
is
AUTO
set to the low level so that only
Mode
stations with strong signals are
received. If no stations could
be
received, the reception sensitivity
is increased so that stations with
weaker signals
can also be
received.
Because the reception sensitivity
for automatic scanning
is set to the
high level from the start, even
OX Mode stations with weaker signals can
be received. (Signal crossover
may result
in some stations being
hard to hear.)
~ATTENTION
When an optional HD Radio tuner unit is
connected, reception sensitivity is set to the
AUTO Mode. The
OX Mode is unavailable.
(U.S.A. only)
I
Check that the main unit is in
standby.
I
Press and hold button [1] and the
~/MENU] button simultaneously
for more than three seconds.
The mode switches between AUTO
mode and
OX mode each time the
buttons are pressed.
44
Changing the radio band location
The location for the radio bands used between
the North American region and the Asia/
Australia/Latin region
can be switched. The
default setting
is USA (North America).
~ATTENTION
When an optional HD Radio tuner unit is
connected, radio band location is set to USA.
Other radio band locations are unavailable.
(U .S.A. only)
I
Check that the main unit is in
standby.
2
Press and hold button [3] and the
~/MENU] button simultaneously
for more than three seconds.
The radio band switches in the order
shown below
each time the buttons
are pressed.
USA ~ ASIA ~ AUS ~ LATIN ~
USA· ..
When the power is turned on, stations
will
be searched for automatically, and
stored in buttons [1] to [6].