Owner's Manual
Table Of Contents
- Reference Guide
- Owners Manual (Downloaded from Eclipse Web Site, Not Supplied with Product)
- Reset
- Clock Set
- Demo Mode On / Off
- Removing / Attaching the Faceplate
- Table of Contents
- Parts & Controls
- Basic Operation
- CD / MP3 / WMA Operation
- USB Music File Player Operation
- Bluetooth Audio Operation
- Bluetooth Hands-Free Function
- Tuner Operation
- Using the Remote Control
- ESN Security
- Adjusting Audio Settings
- Display Adjustments
- Function Menu
- CD Chaner Control
- HD Radio Tuner Control
- XM Satellite Radio Tuner Control
- Sirius Satellite Radio Tuner Control
- iPod
- AUX Input
- Messages
- Troubleshooting
- Specs
- Installation Manual
- Warranty
About
the
optional
unit
Others
Connecting a portable audio
player
to
the AUX
jack
Use a commonly available accessory cable with
an RCA connector or
an
optional AUX105 to
connect a portable audio player to the AUX
(auxiliary) jack of this system.
There are 2 connection terminals
on
this main
unit; one for the RCA connector and the other for
the optional
LAN
cable
(AU
X 105). The default
setting for AUX is
OFF.
I
Turn
on
the portable audio player
and start its play function.
The AUX mode is activated.
For details, refer to "Switching Audio
Modes" on page 18.
~ATTENTION
• While the AUX mode is activated, actions
such as turning off the audio player
or
pulling out the connection cord may cause
noise spikes that can damage the system
speakers. Be sure to avoid this possibility
by turning off system power
or
switching
from the AUX mode to another mode before
shutting off or disconnecting the portable
audio player.
• Audio output levels for the various devices
that can
be
connected using this method
will differ. Carefully adjust the volume until
the output level
of
the connected player is
known.
• Before using a portable audio player
in
a
vehicle, read the player's operation manual
carefully and confirm problem-free
operation
in
the vehicle before proceeding.
• When you connect an optional LAN cable
(AUX 105) to the main unit, other optional
equipment that uses E-LAN cannot be
connected.
108
Switching the
AUX
mode on
and
off
I
Press the
~/MENU]
button
for
more than one second.
The Menu selection mode is activated.
2
Press the [SELECT] (Up/Down)
button
to
select FUNC, and then
press
the
[ENTER] button.
The function mode is activated.
II
Press the [SELECT] (Up/Down)
button
to
select AUX ON/OFF.
The AUX ON/OFF mode is activated.
II
Press the [SELECT] (Up/Down)
..
button
to
select the ON/OFF mode.
Press the button to switch the mode as
follows:
Up:
Mode is
ON
Down:
Mode is OFF
The selected settings will take effect.
Switching the
input
system
When using
an
optional AUX cord (AUX105), the
main unit
can
be
switched between RCA input
and optional AUX cord (AUX105) input.
I
Press the [MODE] button
for
more
than one second.
The system will switch between RCA
input and optional AUX cord input
each time the button is pressed.
RCA input (INPUT) B Optional AUX
cord (SUB INPUT)