Owner's Manual

Various Settings
I!I Press the [SELECT] (Up/Down)
iii button to set the slope.
The slope can be set to "Pass", "6dBI
oct", "12dB/oct", "18dB/oct" or "24dBI
oct",
Up:
The slope becomes more gentle.
Down:
The slope becomes steeper.
I!I Repeat the steps 3 to 5 to change
iii the settings for each channel.
Multi-harmonizer settings
(Harmonizer)
This function uses harmonic synthesis to restore
the high-frequency component that is lost as a
result of the compression process,
so that
fresher sound
can be obtained during MP3/
WMA, USB memory playback.
II
Press the [SELECT] (Up/Down)
button to select Harmonizer.
II Press the [ENTER] button.
The harmonizer setting mode is
activated.
II Press the [SELECT] (Up/Down)
iii button to select a setting item.
When the button is pressed, the
setting item changes
in the following
order.
... BLow B Hi B OFFB ...
Hi:High effectiveness
Low:Low effectiveness
The selected settings will take effect.
76
Non-fader settings (Non-F
Setting)
• Non-fader phase (Phase)
The merging of sound between the front and
rear speakers
and the woofer can be
improved by selecting the phase. Switch the
phase
to a phase which lets the speakers
combine without any disharmony.
• Non-Fader Output (Output)
Non-Fader Output can
be stereo or mono.
Select the method that matches the output
method for the sub-woofer system that is
connected to the main unit.
II
Press the [SELECT] (Up/Down)
button to select NF Setting.
II Press the [ENTER] button.
The non-fader setting mode is
activated.
Non-fader phase settings (Phase)
II
Press the [SELECT] (Up) button to
select Phase.
2
Press the [SELECT] (Right/Left)
button to select Reverse or
Normal.
Right:
Reverse
Left:
Normal