Owner's Manual

Various Settings
IIPress the [SCREENfTEXT] button.
"DISC" flashes
on the display.
You will have five more attempts to
insert correct disc.
BInsert the Key CD into the disc slot.
"OK" will be displayed for two seconds
and then the
CD will be ejected.
rnATTENTION
• If an incorrect CD is inserted, an "ERR_"
("ERR" and error number) message will
appear for two seconds, after which the CD
will be ejected.
• This process cancels the protection for ESN
main unit.
NOTE
If after 5 tries the correct Key CD is not
inserted, the display reads "CALL".
Contact Eclipse for assistance.
It is easy to forget the name
of your
Key CD. Make a note
of the album
name to remind yourself. (Refer to
page
118.)
62
How to turn the security
indicator on/off
Once ESN security is activated, the indicator
flashes whenever the vehicle's ignition switch is
turned
off, warning potential thieves that the main
unit
is protected. However, if do not want this
visible deterrent, it may
be turned off.
With the main unit in standby, and
while pressing button [2], press
the [SCREEN] button, and hold
both
for more than one second.
2
The "IND. FLASH" message or the
"IND.···-" message appears on the
display.
"IND. FLASH" means the security
indicator will flash when the vehicle's
ignition switch
is off, and "IND.-----"
means it will not. Repeat the above
steps to reactivate the flash mode.
How to read the Electronic Serial
Number
I
Check that the power of the main
unit is in standby.
While pressing
button [4], press
the [SCREENITEXT] button, and
hold both
for more than one
second.
After "ESN" appears on the display, an
8 digit number will appear. This
number is the Electronic Serial
Number (ESN) of the device.
You may
use this number to identify your
Eclipse CD7200 mkll
in the event of
theft recovery.