Owner's Manual
Table Of Contents
- Reference Guide
- Owners Manual (Downloaded from Eclipse Web Site, Not Supplied with Product)
- Reset
- Clock Set
- Demo Mode On / Off
- Removing / Attaching the Faceplate
- Table of Contents
- Parts & Controls
- Basic Operation
- CD / MP3 / WMA Operation
- USB Music File Player Operation
- Bluetooth Audio Operation
- Bluetooth Hands-Free Function
- Tuner Operation
- Using the Remote Control
- ESN Security
- Adjusting Audio Settings
- Display Adjustments
- Function Menu
- CD Chaner Control
- HD Radio Tuner Control
- XM Satellite Radio Tuner Control
- Sirius Satellite Radio Tuner Control
- iPod
- AUX Input
- Messages
- Troubleshooting
- Specs
- Installation Manual
- Warranty
lI'nsert
the
Key
CD
into
the
disc
slot.
"CANCEL" will be displayed and the
CD will be ejected.
ESN
is now
deactivated.
mATTENTION
If a
CD
other than the Key CD is inserted, the
registration cannot
be
cancelled.
In
this case,
the "ERR" message is displayed for two
seconds, and the CD playback mode is
activated.
II
Press the [
~
(OPEN/EJECT)]
button.
The front panel closes.
How
to
change
the
Key
CD
II
First, cancel the
existing
Key
CD.
Refer to "How to cancel the Key CD".
EI
Next,
program
a
new
Key
CD.
Refer to "How to program the Key
CD".
How
to
resume
normal
operation
(ESN
security
lock
out)
If power is disconnected while ESN security is
active (a Key CD was programmed),
operation is disabled until power
is
restored
and the main unit unlocked. Follow this
procedure to resume normal operation.
When the
power
is
turned
on
after
the
battery
power
has been
disconnected,
the
"SEC"
message
is
displayed
for
two
seconds. The
message
then
changes
to
the
"DISC"
message. Press
the
[~
(OPEN/EJECT)]
button.
ESN
security operating procedure
Ellnsert
the
Key
CD
into
the
disc
slot.
"OK" will be displayed for two seconds
and the CD will begin playing.
mATTENTION
• If the incorrect CD is inserted, an "ERR_"
("ERR" and error number) message will
appear for two seconds, after which the CD
will be ejected.
• If "ERR5" (the 5th time an error has
occurred) appears
on
the display, the
[HELP] message will appear, and the CD
will be ejected.
If
the "HELP" message
appears, perform the ESN security lock out
operation by following the procedure in
"What happens
if
an incorrect CD is
inserted?"
on
page 61.
•
You
must be use the same CD used for Key
CD programming; a duplicate CD may not •
work properly.
What
happens
if
an
incorrect
CD is
inserted?
1
After
the
5th
incorrect
attempt,
the
"HELP"
message
will
be
displayed
for
five
seconds.
"HELP" will be displayed for 5
seconds. Then the serial number will
be displayed.
I
Press the
[~
(OPEN/EJECT)]
button
to
close
the
front
panel.
3
While
pressing
button
[6],
press
the [SCREENITEXT]
button,
and
hold
both
for
five
seconds.
"SEC" will be displayed for two
seconds. Then the six digit rolling code
will be displayed.
61