Owner's Manual

Operation
mATTENTION
Number of phone numbers that can
be registered in the phonebook
• If there is no space remaining in the main
unit for phonebook data, the "MEMORY
FULL" message appears
on the display
when an attempt is made to transfer data
from the cell phone.
• Some cell phones cannot transfer all
of the
phonebook data at once.
In this case,
transfer one data at a time.
• If the battery terminal
of the vehicle is
disconnected, the phonebook data
registered in the main unit will be deleted.
Setting Auto Answer
When there is an incoming call, the phone can be
set to answer it automatically five seconds after
the phone starts ringing.
Press the [SELECT] (Up/Down)
button while
in the Phone Setting
selection mode to select Auto
Answer.
BPress the [ENTER] button.
II
Press the [SELECT] (Up/Down)
button to select ON or OFF.
ON:
Auto Answer is activated
OFF:
Auto Answer is disabled
56
mATTENTION
The default setting for Auto Answer is OFF
(Auto Answer
is disabled).
Setting the ring tone
The ring tone can be set on or off for incoming
calls. Ring tone
is set ON by default.
Press the [SELECT] (Up/Down)
button while
in the Phone Setting
selection mode to select Ring
Tone.
B Press the [ENTER] button.
II
Press the [SELECT] (Up/Down)
button to select ON
or OFF.
Setting Auto Answer for registered
cell phones
Cell phones which have been registered to the
main unit will
be connected automatically, if the
main unit
and the Bluetooth are in an area where
connection is possible.
Auto answer is set
ON by default and may not be
available for all cell phones.
Press the [SELECT] (Up/Down)
button while
in the Phone Setting
selection mode to select Auto
Connect.
BPress the [ENTER] button.
II
Press the [SELECT] (Up/Down)
button to select ON
or OFF.
ON:
Connects automatically.
OFF:
Must be connected manually.