Operation Manual

17
Introduction
Route display
When setting your destination, the route all the way to the destination point is displayed.
● Route guidance will occur only when the present location appears on a dark blue line
().
Vehicle position mark
The present location and the heading of the vehicle are displayed.
Scale display
The reduction scale of the map being displayed is indicated.
The length of the appearing in the screen above represents 100 yd.
GPS mark
This mark will appear when the device is using absolute positioning data from GPS satellites.
● See page 19 for information concerning this indicator. There may be misalignments
depending on the satellite conditions.
RDS-TMC mark
This mark is displayed when RDS-TMC information is being received.
When regulatory information is received, the mark becomes a touch switch.
: Receiving
: Receiving regulatory information
: Receive regulatory information pertaining to the route (touch switch)
Remaining distance display
The distance from the present location to the destination is indicated.
● While route guidance is in progress, the distance to the destination (calculated based on the
current route) is indicated.
● When deviating from the set route, the distance to the destination in a straight line is
indicated.
● Refer to the section "Switching the arrival time / remaining time /remaining distance
display" on page 140 for information on how to switch the remaining distance display.
Required time display/destination mark
The following marks appear depending on the situation.
Continue to the next page