Owner`s manual

267
267
You can adjust the Back Eye Camera guide
lines as needed.
WARNING
CHECK
Before displaying the guide lines, make sure
to align them with your vehicle.
When an optional back eye camera is
connected, the guide lines are set to either
the normal mode. To use a mode that has
not set guide lines, cancel the display of
guide lines.
If the Navigation screen is displayed,
change to the Multi screen or Audio
operations screen before performing this
operation.
If is not displayed, touch .
If Camera switch is not displayed, touch
to change the page.
Adjusting the guide lines
Be sure to turn the ignition switch off when
getting off the vehicle to apply markings.
Stop the vehicle in a safe location before
adjusting the guide lines.
1
Apply two line markings with packing
tape, etc. on the ground at a distance
of approximately 20 cm (0.656 ft) from
each side of the vehicle.
2
Move the vehicle approximately 2.5 m
(8.2 ft) straight ahead, and then apply
a line marking on the ground so that it
is under the rearmost position of the
vehicle.
Approximately 20 cm (0.656 ft)
Approximately 20 cm (0.656 ft)
Rearmost position
3
Apply markings (four positions) on the
ground at distances of 50 cm (1.64 ft)
and 2 m (6.56 ft) from each end of the
line marking that is applied as the
rearmost position of the vehicle.
4
Touch .
5
Touch .
50 cm (1.64 ft)
2 m (6.56 ft)
Info
Info
Camera