User manual

6
Using The Eclipse II Dowser
Channel Setting
The Eclipse II Dowser is a member of the Coloram II family of products and operates
from the Coloram II Power Supply. See the Specification section of this manual for
detailed dowser information.
Each dowser is assigned a DMX address to which it will respond. The DMX
addresses are set via the rotary switch and third DIP switch located on the bottom of
each dowser in combination with the Coloram II Power Supply starting DMX channel.
Valid DMX addresses are 001- 512. The Eclipse Dowser uses one DMX channel.
Set the power supply starting DMX channel by using the SETUP menu. This is the first
channel in a block of consecutive DMX channels assigned to that power supply. The
channel numbers assigned to, or designated for, the dowsers will be within the lower
half of the block of DMX channels displayed at the power supply.
Note: See the Coloram II User Manual for more information on the power supply and
channel setting.
Set the channel for each dowser by using the rotary switch and third DIP switch. The
switch settings and the 24 channels they represent are as follows:
Rotary
Switch
DIP Switch
#3
Dowser Channel
1
1-12
1
2
1-12
2
3
1-12
3
4
1-12
4
5
1-12
5
6
1-12
6
7
1-12
7
8
1-12
8
9
1-12
9
A
1-12
10
B
1-12
11
C
1-12
12
1
13-24
13
2
13-24
14
3
13-24
15