Service manual

DCB, DCFCB and DCFCTB Models

Installation

Pole Mounting

1. Remove any batteries from the battery box before lifting the control/battery box.

2. Use a crane to lift the control/battery unit to the desired mounting height along

the pole.

3. Use the crane to hold the control/battery unit against the pole so that the four

mounting holes on the mounting channel can be used as a template to drill four

3/8” holes at least 3-1/2” deep.

4. Attach the control/battery box to the pole using four user supplied 1/2” x 5” lag

bolts. Slide a user supplied 1/2” flat washer onto each bolt before threading the

bolt into the pole. Ensure the channel is plumb and straight. Do not bend the

mounting channel by over tightening the lag bolts. Notch the pole or use shims if

necessary to provide a flat stable mounting surface.

5. Mount a user supplied fused disconnect switch on the pole beneath or opposite

the control/battery box assembly in accordance with Local and National

Electrical Codes.

6. If the optional Transformer/Rectifier is required, drill three 3/8” holes at least

3-1/2” deep using the Transformer/Rectifier as a template. Attach the cabinet to

the pole using three user-supplied 1/2” x 5” lag bolts. Slide a user-supplied 1/2”

flat washer onto each bolt before threading into pole.

Flat Surface Mounting

1. Remove any batteries from the battery box before up righting the control/battery

box.

2. Prepare the mounting surface for hanging the assembly using the steel channel as

a template.

3. Attach the control/battery box to a wall or other substantial vertical surface using

the four 5/8” mounting holes.

4. Mount a user supplied fused disconnect switch in accordance with Local and

National Electrical Codes.

5. If the optional Transformer/Rectifier is required, attach the cabinet to a wall or

other substantial vertical surface using the three mounting holes. Make sure that

the mounting surface and mounting method selected can safely sustain the weight

of the transformer. The weight of the Transformer/Rectifier is approximately

150 lb.